Installing a sensor in fabric with the Motion Sensor 360 Pinhole
Did you know the pinhole variant of our Motion Sensor 360 can be installed in fabric?
This makes it an ideal discreet sensor for cinema seating, aisle lighting or integrated into fabric headboards and other custom furniture.
The rear-mouting pinhole Motion Sensor 360 is compatible with any material that is 5mm thick or less. And with just 15mm of sensor on display, your customers will barely know it’s there.
Installation steps for fabric
Pass through fabric
With the larger nut removed, pass the sensor through the fabric, and any stiffening you may add.
Secure from front
Put the larger nut back onto the sensor’s thread with just one or two turns.
Secure from rear
Tighten the smaller nut against the back of the fabric, foam or stiffener to secure the sensor.
This Volt-free sensor is compatible with Control4, Loxone, Lutron, Rako and many other automation systems.